You also must be sure that you have cleaned the entire coil this means deep inside the coil as well as its surface. Use a high sudsing detergent that's safe for evaporators. The sudsing action gets deep in the coil, and helps bring the dirt and bacteria to surface.
You don't need a special chemical to do the job. I use a combination of a standard coil cleaner, and concentrated Lysol that I buy from the grocery store in the good old brown bottle. I use the maximum strength mixture (or even a little stronger) that's recommended by the directions on both of the chemicals. I reapply the solution two or three times to be sure the coil is clean and disinfected.
How do I know when a coil is clean? If I don't get a lot of foaming action, I know the coil isn't clean. It's only when the coil is filled with foam that I know the job is being done.
Your work area can become very messy with all of this foam, so be sure you take care not to let it get everywhere. Be prepared to control the foam!
After this thorough cleaning, rinse both the coil and the drain line. This will get rid of all the disinfectant, as well as the bacteria that was causing the odor in the first place.
If you follow these simple rules, you'll have success cleaning up your customers' dirty socks. Believe me, getting rid of that odor will make them very happy.
Mitchell Bagwell is co-owner of O'Neill-Bagwell Cooling and Heating, Myrtle Beach, SC. He can be reached at 843/385-1917.
































